Zero to MillionOrder one

Paper robot

Sample. Made by Claude, an AI model.

A friendly desk robot with a heart on its chest. A cut-and-fold paper figure made of 6 little boxes. Print, cut, fold, glue.

Finished figure

front back

Drawn from the same artwork as the sheets below. Stands about 94 mm (3.7 in) tall.

Tabs on every box

TabIs on theGlues
Aback wallbehind the left wall
Bleft wallbehind the top
Cright wallbehind the top
Dback wallbehind the top
Eleft wallbehind the bottom
Fright wallbehind the bottom
Gback wallbehind the bottom

Parts

PartWidth × height × depth
Head44 × 36 × 36 mm
Body36 × 40 × 24 mm
Left arm12 × 34 × 14 mm
Right arm12 × 34 × 14 mm
Left leg14 × 18 × 18 mm
Right leg14 × 18 × 18 mm

How to build it

  1. Print the 2 sheets at 100% (“actual size”, not “fit to page”) on A4 or US Letter. Thin card or heavy paper, about 120–160 gsm, folds best. Check the 50 mm bar with a ruler.
  2. Cut out each part along the solid lines. Keep the grey lettered tabs attached.
  3. Score every dashed line with a ruler and an empty ballpoint pen, then fold them all away from you, so the print ends up on the outside.
  4. Build each box the same way. Glue tab A behind the free edge of the left wall, which closes the four walls into a tube. Fold the top down and glue it onto tabs B, C and D. Fold the bottom up onto tabs E, F and G. Glue goes on the printed side of each tab.
  5. Glue the bottom of the Head to the top of the Body, centred.
  6. Glue the arms (Left arm, Right arm) flat against the sides of the Body, tops level with its top. “Left” and “right” are as you look at the figure from the front.
  7. Glue the legs (Left leg, Right leg) under the Body, side by side, feet pointing forward.
  8. Optional: roll a thin strip of paper into a 3 cm stalk and glue it on the coral dot on top of the head for a real antenna.

Printable sheets

Solid lines are cut lines, dashed lines are folds, grey lettered flaps are glue tabs. 2 pages, sized to fit both A4 and US Letter.

Paper robot · sheet 1 of 2 zerotomillion.net/make/ This bar should measure 50 mm. If not, print at 100% (“actual size”). cut fold ABCDEFG Head44 × 36 × 36 mm ABCDEFG Body36 × 40 × 24 mm ABCDEFG Left arm12 × 34 × 14 mm
Paper robot · sheet 2 of 2 zerotomillion.net/make/ This bar should measure 50 mm. If not, print at 100% (“actual size”). cut fold ABCDEFG Right arm12 × 34 × 14 mm ABCDEFG Left leg14 × 18 × 18 mm ABCDEFG Right leg14 × 18 × 18 mm